Shop
Showing 13–24 of 229 results
-
A-A2280 – Remote Volume Control for Redback Amplifier Dual Cover
$40.53+GSTAdd to cartLearn MoreConnects via figure 8 cable to the “remote volume” terminals of the amplifier. Enabling overall volume to be adjusted as required. Features a PCB jumper to reverse the volume control direction. Maximum cable length 100m.
-
A-A2305A – Dynalink Attenuator Volume Control Stereo 60W Dual Cover
$132.82+GSTAdd to cartLearn MoreThis stereo volume control is rated at 60 watts (30W per channel). Fully self-contained on a single gang switch plate. 11 settings plus off. Complete with wiring instructions. All connections are via screw terminals mounted on the PCB.This stereo volume control is rated at 60 watts (30W per channel). Fully self-contained on a single gang […]
-
A-A2312A – Redback Attenuator Volume Control Stereo 100W Dual Cover
$151.25+GSTAdd to cartLearn MoreThis stereo volume control is rated at 100 watts (50W per channel). It features selectable impedance matching, allowing up to 8 pairs of speakers to be controlled. Includes 11 settings plus Off. Connections are made via a pluggable terminal block. 60mm mounting depth.This stereo volume control is rated at 100 watts (50W per channel). It […]
-
A-A2339 – Redback Attenuator Volume Control 100W 100V Line With Relay
$163.98+GSTAdd to cartLearn MoreThis controller has been designed to install to a double electrical flush box or wall mounting block (A-P8056). Massive 100 watt capacity available. 11 settings plus off. Fitted with a 24 volt override relay.
-
A-A2365 – Attenuator Volume Control 5 Zone Evac 100W / 100V Line
$646.25+GSTAdd to cartLearn MoreThese controllers can be configured as either five single inputs to five outputs or one input to five outputs. Each zone has a 100W load capacity, with a total panel capacity of 500W. The 100W model has ten position plus off. The input and outputs are connected via heavy duty screw terminals on the rear […]
-
A-A2384 – Dynalink 2 Channel Speaker Switch with Volume Control
$242.48+GSTAdd to cartLearn MoreAllows on/off switching and level control of two sets of either 4Ω or 8Ω stereo speakers. Includes impedance correction circuit and a protection switch for use with 4Ω speakers. Power capacity up to 50W RMS per channel. Each stereo speaker set has an independent 10 step volume control plus on/off switch and flip-tab terminals on […]
-
A-A2510 Passive DI Box
$55.70+GSTAdd to cartLearn MoreDirect injection (DI) boxes are used to convert high impedance unbalanced signals from guitars or other musical instrument pickups to a low level balanced output signal. This enables the signal to be transported over long distances without picking up noise or hum. Earth and hum loops are isolated from powered equipment such as keyboards. It […]
-
A-A2522 Line Isolation Transformer 10kΩ; to 600Ω; XLR
$69.80+GSTAdd to cartLearn MoreThis unit can be used for balancing a line level signal (converting a 10kΩ unbalanced signal to 600Ω balanced) and as an isolation unit to prevent hum loops in audio systems. Specifications Frequency response: 20 Hz – 20kHz +/- 3dB Input level: 0.775Vrms Output level: 0.19Vrms Maximum output level before distortion: +18dBm Distortion: <0.05% Signal […]